欢迎您光临康鹏华彩新能源技术有限公司官网!

联系我们 收藏本站

咨询服务热线 工业油电话:0531-58589003,13256121992
车辆油:0531-87581191,13156111992

热门关键词搜索: 润滑油工业润滑油 润滑油厂家

您的当前位置:主页 > 新闻资讯 > 公司新闻 >

如何提高导热油的使用寿命?

来源:www.jnkangpeng.com 编辑者:康鹏华彩新能源 发布日期:[2017-07-07 14:43] 浏览:|

  提高导热油的使用寿命注意几点,必须按说明的取样化验导热油,发现问题,立即更换新的导热油,突然停电,循环泵停止,流速等于0,停炉,必须养按照说明操作规程执行,一般使导热油温度降到100度以下方可停止S热油泵。

  To improve the service life of heat conductive oil must pay attention to the following, according to the sampling test of thermal oil, that found the problem, replace the new oil, immediately a sudden power outage, circulating pump stop, flow rate is equal to 0, stop, must keep in accordance with the instructions for execution, generally the heat-conducting oil temperature dropped to 100 degrees to stop S heat pump.

  1、一般使用半年后,必须按说明的取样化验导热油,发现问题,立即更换新的导热油,但必须注意,不可混合不同种类的导热油。

  1, the general use of six months later, you must follow the instructions of sampling, testing heat conduction oil, and found problems, immediately replace the new heat transfer oil, but must pay attention to, not mixing different types of heat transfer oil.

  2、防止导热油的氧化。严谨导热油>50度时与空气接触;这样SS会使导热油发生裂解,其速度快的惊人,且后果非常严重,要求试车人员在正常工作后,将辅助排气管道上排气阀关闭,切记。

  2, to prevent the oxidation of heat conduction oil. Rigorous thermal oil >50 degrees in contact with the air; this will make SS thermal oil cracking, its speed, and the consequences are very serious, for the commissioning personnel in normal work, the auxiliary exhaust pipe exhaust valve closed, remember.

  3、突然停电,循环泵停止,流速等于0。由于炉膛内耐火蓄热体继续放S热是炉管中的导热油超温,而产生裂解、结焦,长期多积累也会使炉管炸坏,殃成大祸。因此要求样按说明操作。

  3, sudden power failure, the circulatory pump stopped, the flow rate is equal to 0. Because the furnace refractory is heat regenerator continue to put S in the furnace tube heat conducting oil temperature, and pyrolysis and coking, long-term accumulation will make the furnace tube damaged, calamity into catastrophe. So ask for instructions.

  4、合理地选择导热油炉。按说明选择导热S油,且严谨超温使用,千万不能S图省钱买不合格的油,更不能自己乱兑导热油,否则几个月多半年的时间,炉管堵塞,造成火灾,后果不堪设想!

  4, reasonable selection of heat-conducting oil furnace. According to the choice of S thermal oil, and strict over temperature do not use S diagram to save money to buy substandard oil, but can not mess against the heat-conducting oil, or a few months up to six months time, jam, furnace tube caused by fire, the consequences be unbearable to contemplate!

  5、停炉,必须养按照说明操作规程执行,一般使导热油温度降到100度以下方可停止S热油泵。

  5, stop the furnace must be kept in accordance with the instructions operating procedures, the general heat conduction oil temperature below 100 degrees, can stop the S hot oil pump.

  6、严谨随意超温操作,多加燃料,加大风量,使导热油S处于超温状态,这样导热油裂解结焦即可发生,长久下去就会发生大的事故。

  6, rigorous, optional, ultra temperature operation, more fuel, increasing air volume, so that heat conduction oil S in the ultra warm state, so that heat transfer oil cracking coking can occur, long term will happen big accident.

同类文章:

文章标题:如何提高导热油的使用寿命?

推荐阅读/ Recommended reading

1、粘度和粘温特性:粘度是液压油的主要指标,对系统的平稳工作有着重要影响。粘度过小时,润滑表面容易产生磨损,从而使液压元件的内漏和外漏增加,泵容积效率降低,油温上升...

压缩机与油品常见故障诊断[2018-01-05]
详述导热油的成分与种类有哪些[2018-03-29]
避开四大误区 正确添加汽车润滑油[2017-10-23]
润滑油厂家浅析润滑油应如何鉴别[2018-06-29]
工业润滑油的行业发展[2018-04-11]
导热油厂家分享如何挑选优质导热油?[2018-07-19]
导热油应用行业及重要指标[2017-12-04]
润滑油具有哪些作用特点![2018-09-20]
润滑油在使用过程中为什么会出现变黑发[2017-08-21]
合成润滑油最佳涡轮增压车型小常识[2018-05-14]
  • 扫一扫,访问手机站